I know this thread has been idle for a long time, but don't feel it appropriate to create a new thread....
So, I finally just decided to try and enable the trams, and they don't appear to be working properly....
I edited the ailists.cfg to change the .zug filename from "VA_E1_c3.zug" to "VA_E1_c3_Wien_1.zug", and tried "VA_E1_c3_Wien_2.zug" as well to the same effect, to coincide with the OMSI2 Venna addons I own. This eliminated the file-not-found errors relating to this tram.
Now, I see the tram arriving at the station by the bus depot, activating the crossing signals. The tram sits there for a few moments with the doors open and just the headlight on. Around the same time the tram arrives, the digits on the arrival time on the display board starts to endlessly cycle in descending order in an endless loop, starting with the ones digit and then eventually both digits start to do it.
After a few moments, the four-way flashers on the tram start to flash. The tram will never leave, it just sits there forever. The signal facing the tram stays red. Both the "1" and "2" trams do the same thing.
Only way I can get it to go away and stop the crossing signals is to advance time to refresh the AI.
Is this compatible with the OMSI 2 Vienna addons available on Steam?
Is there way to fix this, or should I just deactivate the trams?