Problem with buses (Still not work)

The forum is in reduced operation. The Addon and Support forums remain open.
Please note that OMSI is no longer under development. Some of the developers are now working on a new simulator. Further information concerning the LOTUS-Simulator can be found here.

    Where can be problem, while I have in some my modified buses only driver and I have this error in logfile? (In one bus I have other error and I attempt something, and the bus is function)
    63704 13:07:39 - - Error: Fehler bei Bereichsprüfung: TUV 0
    I attempt the same thing too, but same error.
    At first I had at least the wheels (and of course the driver).
    Then I saw that I had a bad name of one .o3d, I corrected it, and since then is just the driver and the error. One attempt did not work out.

    Logfile.txt
    Problem is with b732.
    There is 674 10:53:18 - - Error: vehicles\1Karosa CX34\model\BUSE2\Zadlin-700zad900.o3d – o3d reading failed - Could not read the o3d file! Die angegebene Datei wurde nicht gefunden
    and this 1713 11:03:21 - - Error: vehicles\1Karosa CX34\model\DPMCB\B732.1654_kuzov-273.o3d – o3d reading failed - Could not read the o3d file! Die angegebene Datei wurde nicht gefunden
    This I fix it, but I have only driver and same error.

    I found, that the .o3d, which will have in model.cfg textexturen, must be texture in .bmp, this I test in Karosa B741, where I thought, that this can be problem, why I had only driver in main (I moved buse panel). And this was right, now I haven't problem with this bus.
    I have in .o3d, where I use textexturen, texture in .bmp, but in B73X I reoait ir and I haven't problem. And in my Capacity I have only trail and driver, but I have in .o3d, where I use textexturen, texture in .bmp.
    I will upload modified Citaro and you can find problem.