With Version 1.0, Newer Engine script 1.5 already included!
Well file this under yet another sound mod for the Man Nl202. This modification adds an ZF transmission to the Man Nl202 complete with 1st to 5th gear whine. With up shift sound sets for the 1-2, 2-3 and 4-5 gears. admittedly, the gear whines are actually taken off of an recording of the Mercedes 0405. What I did was i used the Engine RPM / Gear Ratio formula to triangulate the axle rpm speed of each shift. Since in the recording which I have used, the shifting speed is roughly ~1700-1800 rpms without kickdown enabled. Since I have tweaked the ZF transmission to shift at 1800 rpm in each gear, I have set all of the sounds to reflect the actual axlerpm of its prototype. I then recorded the Wheel RPM values by pausing OMSI while in the debug window of each shift.
The engine sounds consist of an engine rattle sounds, engine base sounds, as well as engine rpm sounds.
- Engine Sounds
- Interior
- ||-- Loaded (Acceleration-Engine Rattle)
- ||-- non-load (no throttle)
- Exterior
- ||-- Loaded (Acceleration-Engine Rattle)
- ||-- non-load (no throttle)
- Axle noises
- Transmission Noises
- - Upshift
- - Downshift sounds
- - Gearwhine
- ||-- Loaded (Acceleration)
- ||-- non-load (no throttle with retarder on)
As far as the consist or configuration files are concern. I found an flaw in the *.bus file. The Wheel radius for the front and rear wheels were at set at the same values. It may have been the cause of that freeze bus, but not entire sure. I noticed after giving the radius the correct value, the bus played just like the Man Sd202 while in the sim. The D0836 engine script has been replaced with its turbocharged counterpart.
The RPMS are as follows:
While in drive, Max RPM is around 2400-2450 RPMS, while in neutral, the RPM can climb up to 2600-2650 rpms. The Bus is also govern to 85 kph as well. From what I have read, this is the standard. Also implemented nemeza fuel consumption script, thank you nemeza!!
To change the engine speed governor,
engine_constfile_D92_ZF_D08_turbo.txt